Maintenance Method Of Special Welding Chuck For Positioner

Maintenance Method Of Special Welding Chuck For Positioner

The welding chuck is an important part of the automatic welding positioner. It needs frequent maintenance and maintenance. When special circumstances occur, the frequency of welding maintenance must be increased. This can greatly extend the service life of the welding chuck and improve work efficiency. The correct maintenance method of welding chuck is as follows:

1. After the chuck is used, the body and sliding surface of the welding chuck must be cleaned with an air gun and other tools. This can ensure that the welding chuck still has good accuracy after long-term use, so it is very important to regularly lubricate the work of the welding chuck.

2. Apply molybdenum disulfide grease (the color is black) at least once a day, and put the grease into the nozzle of the welding chuck until the grease overflows the jaw surface or the inner hole of the welding chuck (inner hole protective sleeve and connecting nut).

Welding Chuck

3. In order to prevent the internal rust of the welding chuck and reduce the holding force, the workpiece cannot be clamped, so it is better to use cutting oil with an anti-rust effect. Using cutting oil can prevent rust inside the welding chuck.

4. After the operation is completed, an air gun or similar tool must be used to clean the surface of the welding chuck body and the slide space.

5. The welding chuck should be removed and cleaned at least once every 6 months to keep the sliding surface of the jaws clean and lubricated to improve the service life of the welding chuck.

Pipe Pinching Rotator

6. Check each part for cracks and wear. Cut cast iron at least once every two months to clean it thoroughly. If the damage is severe, replace it with a new one immediately.

7. Different clamping workpieces must adopt different methods. If it is used to clamp irregular workpieces, the welding chuck will be damaged.

8. When the pressure of the welding chuck is abnormal, the welding chuck is clamped under high pressure, which will reduce the service life of the welding chuck. Therefore, when it is found that the gap of the welding chuck is too large, a new welding chuck must be replaced immediately.

We are Welding chuck suppliers. Please feel free to contact us if you need or want to know about our products.